HydroMist
HydroMistUSA.com
6
3. Using a 10 mm masonry bit, drill 45 mm (a bit more than 13/4 inches)
deep holes into the wall at marked anchor points.
4. Thread anchors
[D]
onto the wall bracket [E] so that all washers and nuts
are in front of it and sleeves are behind it.
5. Place the bracket and anchor assembly onto the pre-drilled holes and
align anchors to the drilled holes.
6. Hammer the anchors each a little at a time to drive all four completely
into the drilled holes, and anchor is flush against wall.
7. Use a 12 mm wrench to tighten anchor nuts
[C]
onto each bolt. It is
normal and necessary that bolts will draw out a bit while tightening.
8. Place the fan onto wall mount and secure it with (2) included bracket
screws
[B]
using a #2 Phillips screwdriver.
NOTICE!
When securing power cables on outdoor installations, loop them
below and back up to the power outlet. This makes any moisture collection on
the cable drip to the floor instead of into the outlet.
