4
KDF85/Catalytic Carbon Upgraded Filter - HL#22065
HydroLogic only uses the highest grade materials to make our
KDF85/Catalytic Carbon upgraded filter for reducing chloramines.
•
KDF: 0.5 lb copper/zinc media
•
5 micron nominal filtration
•
Meets NSF61 standards
•
Reduces a wide range of contaminants, incuding heavy metals, chlorine, chloramines, sulfur and iron
•
Carbon has enhanced catalytic capability
•
KDF neutralizes chlorine
•
NSF Certified for material safety
•
Bacteriostatic qualities do not allow microbes to breed in filter
Filter Housings:
•
Housing -Polypropylene
•
Cap - Reinforced Polypropylene
•
O-Ring - Buna-N
•
Maximum Temperature -125°F
•
Maximum Pressure - 125 psi
Filter Changes:
The Green Coconut Carbon filter is rated to produce approximately 7,500 gallons of treated water
*
,
or approximately 6-9 months, whichever comes first. This is based on 2 gallons per minute (GPM) flow
rate and source water at 1 PPM chlorine. The sediment filter replacement schedule is dependent on
how dirty your source water is. It is recommended to replace both filter cartridges at the same time.
If you can visibly detect dirt in the sediment filter sooner than 6 months or 7,500
*
gallons of treated
water, this indicates high levels of sediment in your source water and this filter should be changed more
often than the carbon filter. Replacements are available at your dealer.
*15,000 gallons for the KDF85/Catalytic Carbon upgraded filter
Warranty:
HydroLogic products have a one-year warranty solely against manufacturer’s defects. These defects must be noted
and photographed upon receiving the merchandise or when the box is opened. This does not include clogged filters
or membranes due to excessive contaminants, minerals, sediment and/or chlorine in the water. In many cases extra
pre-filtration methods may be necessary to get favorable performance and/or service life from the filters. The warranty
also excludes damage to the unit caused by using the unit outside of the specified parameters. Do not operate unit
if incoming pressure exceeds 125 psi or there is a problem with water hammer spikes. Use a HydroLogic Pressure
Regulator
(HL#10071
), available at your local hydro shop. For other issues that may arise throughout the lifetime of the
product, please contact HydroLogic directly for technical support.
Product returns will only be honored on brand new unopened products in the original packaging and in re-sellable
condition. Any units that have had water run through them or any damage to the box or packaging material will be
refused for return. Any returns with missing parts will be refused. All returns must be preauthorized by HydroLogic.
Do not contact your dealer or distributor for warranty issues. Contact HydroLogic directly.
1-888-H2O-LOGIC
1-888-426-5644
