VGS300 ASSEMBLY
ASSEMBLY OF 3-SHELF SYSTEM (VGS300)
1. Take one of the Upper Side Walls (Part A) and lay it down on the floor (see Fig. 1). Screw two of
the casters (Part D or E) into the inserts in the bottom of the upper side wall by hand. Do not
overtighten the casters.
NOTE:
Make sure that both casters installed into the first upper side wall are the same type, either
with or without brake—both Part D or both Part E.
2. Repeat Step 1 with the other upper side wall and the other two casters.
3. Use a screwdriver or power drill with screwdriver bit to fasten one of the shelves (Part C) to the
side walls at the bottom holes (closest to the wheels) using four of the provided Shelf Mounting
Screws (Part F) (see Fig. 2). The smooth side of the shelf should face upward and the underside
(with mounting holes) should face downward (toward wheels and floor). This is now the bottom
shelf.
4. Install the Cross Bar (Part B) at the opposite/top end of the side walls using two of the provided
screws (see Fig. 3). This will give stability to the structure. You can install the cross bar into either
the front two holes or the back two holes. When the cross bar is installed, it will define the front/
back of the entire rack (when looking at the front, the cross bar should be in the back).
Fig. 1
Fig. 2
Fig. 3
4