49-00HA -
www.hydroair.dk
– August 2009
HA 350 (20-35x21) & HA 550 PUMPS (20-55xx1) FOR WHIRLPOOL
Direction for use
-
Electrical supply 220-240VAC / 50Hz.
-
The pumps must be installed in a place, where there is easy access to the terminal box.
-
If the cable is replaced, the square dimension of the cable must not be reduced.
-
The cables must be of a minimum type H05VV-F fully connected to earth.
-
Ensure that the cable gland is fully tightened.
-
The pump must be protected by a fuse.
-
In order to separate the pump from the mains, a suitable ground fault circuit interrupter, with at least 3
mm break distance on each terminal in the present electrical installation, must be installed.
-
External earth screw on the motor to be used for connection of external equipotential bonding.
Attention!!
A. The pumps must not be used for liquids in excess of 60°C.
B. It is recommended to connect the pump via an electronic control box that has a detection device fitted to
detect the absence of liquid.
C. The installation must be according to the normal power indicated on the label.
D. It is recommended that you consult a state-registered electrician.
E. If
the
supply cord
is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
F. Locate the pump in a dry area with good ventilation.
G. The ambient temperature must not exceed 40°C.
H. The pumps are solely for use in whirlpool and spa systems.
I.
This appliance is not intended for use by persons, including children with reduced physical, sensory or
mental capabilities or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a responsible for their safety.
J. Children should be supervised to ensure that they do not play with the appliance.
Mounting of pump
There are different ways of installing the pump:
1.
The easily accessible rubber feet allow quick installation of the pump,
by screwing 4 pcs. of M6 bolts up into the nuts, that are integrated in
the rubber feet.
2. With a mounting plate 20-0400, you simply screw one M10 bolt or a
threaded pole up into the nut that is integrated in the plate, and the
pump is in place.
