HRC 390
Quick tipS inStructionS
QUICK TIP RF SENSOR:
When using
the Hrc-300-rS-rF with this controller
you’ll need to sync the units to begin
operation. While the programming module
is in the box and connected to ac power, press the
“rF SYnc” button on the lower right side of the
programming module. a red light will activate. now
while holding the rF sensor in your hand activate
the transmitter sync by lightly pressing on the top
of the plastic pin on top of the unit. Hold this in until
the light on the controller blinks indicating the unit
is receiving communication.
QUICK TIP MAINTENANCE:
When de-activating a hard wire
rain sensor move the active|bypass
switch to “
BYpaSS
” (see figure at upper left). When
deactivating a wireless sensor select the on screen
“
BuDGEt
” indicator then select “
SEnSor
” then
toggle
/
to select “
SEnSor actiVE
” or “
SEnSor
BYpaSS
” then “
EntEr
”.
QUICK TIP RF REMOTE:
When using
the Hrc-300-12-rF with this controller you
need to sync the units to begin operation.
While the programming module is in the
box and connected to ac power, press the “rF SYnc”
button on the lower right side of the programming
module. a red light will activate. now while holding
the rF transmitter in your hand activate the
transmitter sync by pressing and holding down any
of the “off buttons”. the transmitter will beep and the
light on the controller will blink when activated.
QUICK TIP MANUAL OPERATION:
With the
stylus select “
ManuaL
” located in the upper right
corner of the home screen. When you desire a
system test of all stations in sequence navigate the
/
to the desired run time and press “
EntEr
”.
individual stations or groups may also be selected
by selecting “
nEXt
” and touching valve selections
1-6 or 1-12 and using the
/
to the desired run
time and press “
EntEr
”. automatic cycles will
resume after manual watering is complete.
QUICK TIP RAIN OR EVENT DELAY:
on the
controller press the then navigate the
/
to
the desired delay 1 to 99 days and select “
Start
”.
QUICK TIP CYCLE AND SOAK
(Multiple Daily
program Starts): on the programming screen select
then select “
cYcLES
” use the
/
to select 1
to 10 daily start times for the selected program,
press “
EntEr
”, use the
/
to select the desired
delay between cycle times 0 to 90 minutes or 2 to 23
hours then press “
EntEr
”. cycles are now set press
“
EXit
” to return to the home screen. Example: if you
scheduled program a to start at 6:00 a.M. and you
selected.
QUICK TIP LOCK SCREEN:
press the to
lock the screen to avoid inadvertently changing set
programming. press to unlock the screen to
re-program.
RAIN SENSOR
ACTIVE | BYPASS
SYSTEM
OFF
ON
ON
ON
NEXT
ALL
OFF
2 min
STATION
STATIONS
CLEAR
10 min
30 min
1
3
4
5
6
7
8
9
10
11
12
2
HRC-300-12-TR
PROG.
