Push Buttons
These push buttons on the controller are used for
programming and other operations:
1 Home/Lock
Used to exit settings; to go into AUTO MODE, or to
lock the touch screen.
2 System Off
A single push will open the Rain Delay screen. A
second push of the button will place the entire
system in OFF mode.
3 Reset (pin hole)
Resets the HRC 390 to factory default settings.
4 RF Sync
Allows the HRC 390 to synchronize with a remote
transmitter or wireless rain sensor (HRC-300-12-RS)
sensor.
5 Rain Sensor
In “Active” position the controller will monitor the
rain sensor, in “Bypass” position the HRC 390
sprinkler controller will ignore the rain sensor. (This
switch is for hard wired sensors only and does not
effect wireless rain sensors. For wireless rain sensor
bypass refer to section 4.)
6 Touch Screen
Use stylus or finger to set programming.
Section 2:
GETTING STARTED
Set Language
• Press the
RESET
button. The controller will now take
you through a step by step programming process.
• Press or on the touch screen to set the language
of your choice (English, Spanish, French, German,
Italian).
• Press
ENTER
.
Set Current Time and Date
• Press or to set the current time. Press
ENTER
.
• Press or to set the current year. Press
ENTER
.
• Press or to set the current month. Press
ENTER
.
• Press or to set the current day of the month.
Press
ENTER
.
Determine a Watering Plan
See page 13 for instructions.
Figure 1:
Front view of touch-screen controller
1
2
3
4
5
n
04
n
6
