Hydro-Force MA72, Owner'S Manual

Page: 6 / 20

4
3. Connection of Solution Hose:
Attachment:

While sliding the sleeve of the female quick
connect towards the housing, press the male
quick connect into the hole.

Once the male quick connect bottoms out in the
hole, release the sleeve of the quick connect.

Press the male quick connect firmly until the
sleeve of the female quick connect locks forward.
Removal:

Slide the sleeve of the female quick connect
towards the housing until the connection
releases.
4. Connection of Vacuum Hoses:
Attachment:

Press the vinyl cuff of the hose onto the
inlet of the vacuum.
Removal:

Pull the vinyl cuff of the hose off of the
inlet of the vacuum.
Note: Wriggling the vinyl cuff from side to side
slightly helps overcome a tight fit.
5. Empty the Recovery Tank:

After unlatching the butterfly latch, lift the
recovery tank by the top-center handle out of the
vacuum body (Steps 1 & 2 above).

Using the lower-rear handle and the top-center
handle, tip the recovery tank forward to empty
the contents of the tank.

At the completion of the job, rinse the tank with
clean water to prevent odors and buildup of
waste in the tank.