1. Be sure power is turned off.
2. Place provided gasket in black of wall mount cover (WMC) plate, and pull fixture wires through WMC
3. Attach fixture to threaded opening in the WMC.
4. Make all electrical connections to the fixture. Attach supply
LINE
wire to the black wire from the fixture. Connect
the Neutral wire from the supply to the white wire of the fixture. Be sure that the ground wire is attached to an
approved grounding source.
5. Attach WMC to mounting surface using the two screws provided or appropriate hardware to support the fixture.
6. Loosen the allen screw in the side of the knuckle and aim the fixture. Retighten the screw in the knuckle.
7. Unscrew the fixture lens cover and install proper lamp type (by others).
8. Replace lens cover making sure that the cover fits snugly.
Wall Box
(by others)
Loosen screw in
knuckle to aim
fixture
Lens cover
Fixture
attaches here
WMC
4600
Fixture
Wall Box
(by others)
Mounting
screws
(provided)
INSTALLATION DIAGRAM
WALL MOUNT COVER
(WMC)
4600 KM
KNUCKLE MOUNT
INSTALLATION INSTRUCTIONS
Installation should be performed by a qualified
electrician in accordance with the National Electrical Code
and relevant local codes.
*IMPORTANT:
Junction Box/Ballast Box must be water tight.
Seal all conduit entries with suitable compound
(e.g. Hydrel PC-21 re-enterable potting compound)
to prevent moisture penetration from the supply
conduit system.
NOTE: HYDREL RESERVES THE RIGHT TO MODIFY SPECIFICATION
WITHOUT NOTICE. Any dimension on this sheet is to be assumed as a
reference dimension: “Used for information purposes only. It does not
govern manufacturing or inspection requirements.” (ANSI Y14.5-1973)
©2014 Acuity Brands Lighting, Inc.
6/19/14
INS-4600_KM
9144 Deering Avenue | Chatsworth, CA 91311
Phone: 866.533.9901 | Fax: 866.533.5291
www.hydrel.com