HydraConnect LLC
Page 4
www.hydraconnect.com
(
720-583-4364
Product Installation
1. Identify a location for the transmitter module that is within 6 feet (2 meters)
of the source. To use the supplied mounting bracket, follow these steps:
a. Determine on which side of the module to attach the mounting bracket
b. Remove the 2 screws from that side of the module and discard
c. Attach the supplied bracket using the two supplied screws per the
picture below:
d. Using the appropriate screws, mount the module through the mounting
bracket holes
2. Connect a High Speed HDMI Male-to-Male cable between the transmitter
module and the source.
3. If used, connect an IR Flasher or Receiver to the designated
connectors.
NOTE THAT INSTALLING AN IR FLASHER OR RECEIVER
INTO THE WRONG CONNECTOR MAY DAMAGE THE MOD-
ULE WHICH WILL NOT BE REPAIRED UNDER WARRANTY.
4. If an automation system IR passthrough is needed, connect a 3.5mm mono
connector cable between the output of the automation system and the IR
input on the transmitter. Connect the IR flasher to the IR output on the
receiver. NOTE: Unlike previous extenders, no adapter cable is required
between the automation system and the transmitter.
5. Connect the properly terminated end of a CAT5e/6 cable to the designated
connector (see Link Cable specifications for cable requirements).
NOTE: DO NOT CONNECT THE CAT5e/6 TO ANY
DEVICE OTHER THAN THE SUPPLIED TRANSMIT-
TER AND RECEIVER, PARTICULARLY NOT TO ANY
NETWORK DEVICE! THE VOLTAGE DELIVERED FROM
THE TRANSMITTER WILL LIKELY DAMAGE SUCH
DEVICES.
