7
English
Digital feeder
DIGITAL FEEDER is an automatic aquarium food feeder with electronic timer
control.
Description
A.
cover
B.
Feeding spout and control
C.
Food compartment
D.
Motor
E.
Battery cover
Timer setting
Attention:
Timer has to be reset every time the batteries are removed or replaced.
Remove cover (E) and insert two batteries taking care to place them with the correct polarity.
Press the SET key to start setting the actual time. Display TIME will flash during this ope-
ration -fig. 2-.
Set hours and minutes by pressing the HR and MIN keys.
Press SET once again to memorise. The TIME symbol disappears and FEED will start flashing
to indicate that you can enter the first feeding time setting.
Set the time by pressing HR and MIN and press SET to memorise and pass to the second
feeding time setting. The second FEED will light up. Press HR and MIN until you reach the
time you wish for the second feeding and memorise by pressing SET.
The display will now show the current feeding time and two FEED - FEED indicating DIGITAL
FEEDER has been programmed for two feeding cycles a day -fig. 3-.
DIGITAL FEEDER will automatically leave the programming mode 30 seconds after the last
key has been touched
Number of daily feeds
It is possible to omit one or both of the programmed feeding cycles at any time.
Press the SET key until the FEED corresponding to the feeding cycle you want to exclude
begins to flash.
Press FISH to cancel the food symbol in front of the mouth of the fish -fig.4-. Follow the same
procedure to omit also the other feeding cycle.
To leave the programming mode press SET or wait 30 seconds for automatic exit.
To restart the function on hold press SET until the FEED symbol flashes and press FISH once
again so that the food in front of the fish’s mouth reappears.
Exit from programming function as explained above.
Manual feeding
Manual feeding can be carried out at any time. Simply press FISH once.
Batteries
One week before the batteries are totally discharged the symbol BATTERY will appear on the
display to indicate that they need to be replaced.
Remember to reprogram DIGITAL FEEDER after replacing the batteries.
Installation
Whilst DIGITAL FEEDER has been specially designed for use in aquariums it is recommended
to place the unit in a position with air circulation to prevent moisture entering the food
compartment.
Release the food compartment (C) by rolling and pulling outwards.
Take off food cover (A) and fill the compartment -fig. 5/6-: do not pack the food too tightly
in the compartment.
Close the food compartment and insert it into position until locking tab clicks into place.
Make sure the positioning marks coincide -fig. 7-.
Place DIGITAL FEEDER on the aquarium hood with the food outlet positioned over the fee-
ding hole in the hood, finally fix with the adhesive tape supplied.
The hole should be at least 40 x 40 mm. If necessary, enlarge the existing hole or cut one
possibly on the side opposite the filter ensuring that the hole is not over the light tubes or
Summary of Contents for MIXO
