Hydmech M16A, Manual

Page: 25 / 76

2.7
AUTO MODE
Energizes CYCLE START button.
MANUAL MODE
No function
ONE CUT MODE
Used to enter length value
MANUAL MODE
After entering an angle value, pressing F2 will cause the screen to read “TO INITIATE MOVE
-
MENT TO XX.X DEGREES PRESS CYCLE START”. Upon pressing “CYCLE START” the head
will swing to the programmed angle.
AUTO MODE
Used to scroll up through job information.
MANUAL MODE
Used for accessing the KERF screen. The KERF screen cannot be accessed while in METRIC
mode and any change made to the KERF value will not be accepted by the controller until it has
been shut down and restarted.
(The standard kerf values are .066 for 1 1/4” blade & .074 for 1 1/2” blade at 90
O
.)
AUTO MODE
Used to scroll down through job information.
MANUAL MODE
Used to clear the length display (shuttle vise position) value.
AUTO MODE
Used to CLEAR the jobs from the queue or job values for whichever job the cursor is at.
F7
•
F8
•
F5
•
F6
•
NAVIGATION AND NUMERICAL KEY PAD
The cursor keys are used to navigate the cursor box on the screen. If the display
has columns, only the UP and DOWN keys are activated. If the display has both
rows and columns, then all four cursor keys are activated.
The numerical keys allow for data to be input as required.