5 | Mounting/installing
HYDAC FILTER SYSTEMS GMBH
40 / 88
MoWa OLF-5Z OLF-10Z 4520794 en-us print
5 Mounting/installing
The following provides information on how to install and con-
nect the filter unit/filter housing, hydraulically and electrically.
5.1 Fastening/mounting the filter unit
The filter unit must be mounted vertically. Fix the filtration unit
by means of four suitable screws, with the mounting base or
the base on the electric motor, depending on the version.
While doing so, make sure that there is sufficient space below
and above the filter bowl respectively to change the filter ele-
ment.
Fig. 11:
Assembly with a mounting base
The dimensions, connections and circuit diagrams for the re-
spective version can be found in the "Annex" chapter.
If the oil level in the hydraulic system is higher than
the filter housing, install additional shut-off devices
at the inlet (IN)/outlet (OUT). These shut-off devices
guarantee that the filter element change will be fast
and clean.
1
2
3
4
5
6
7
8
A
Summary of Contents for OLF-10/Z
Page 87: ......
Page 88: ...www hydac com ...
