HYDAC International MAFH-A, Operating Maintenance And Troubleshooting Manual

Page: 7 / 21

User Manual MAFH-A L-4425
HYDAC En 7
Illuminate Work Area Safely
Illuminate your work area adequately but safely. Use a portable safety light for working inside or under the
machine. Make sure the bulb is enclosed by a wire cage. The hot filament of an accidentally broken bulb can ignite
spilled fuel or oil.
Work In Clean Area
Before starting a job:
- Clean work area and machine
- Make sure you have all necessary tools to do your job.
- Have the right parts on hand.
- Read all instructions thoroughly; do not attempt shortcuts.
Use Proper Tools
Use tools appropriate to the work. Makeshift tools and procedures can create safety hazards. For loosening and
tightening hardware, use the correct size tools. DO NOT use U.S. measurement tools on metric fasteners. Avoid
bodily injury caused by slipping wrenches.
Dispose of Waste Properly
Improperly disposing of waste can threaten the environment and ecology. Use leak-proof containers when draining
fluids. Do not use food or beverage containers that may mislead someone into drinking from them. Do not pour
waste onto the ground, down a drain, or into any water source.
3. Specifications
Average delivered Flow Rate: 1.5 gpm (5.7 L/min)
Pump Flow Rate: 3 gpm (11.4 L/min)
Relief Pressure Setting: 100 psi (6.9 bar)
Weight (Approx.): 295 lbs (134 kg)
Operating Temperature (Hydraulic):
*Depending on Viscosity
40° F to 160° F
(4° C to 71° C)
Operating Temperature (Electronic):
*Depending on Viscosity
50° F to 113° F
(10° C to 45° C)
Environmental Rating: Type 2
Power Requirements: 120 VAC 60 HZ @ 15 A
Fluid Compatibility:
Hydrocarbon Based Hydraulic Fluids
(Viton seals standard)
Viscosity:
70-1000 SUS