Preparing the CTM-SC for operation
Connecting the CTM E module
Attach the CTM-E electrical connector and hoses to the control unit as shown
in the following illustration.
Tighten the connection at the hose tightly to the screw connection on the
CTM-SC. When doing so, tighten the screw connection at the CTM-SC with
an additional fork wrench.
Depending on the type of extraction module, some of the screw connections
may not be required. Block any unnecessary screw connections using screw
plugs.
Checking setting at the level sensor / Setting test liquid
There is an electronic level sensor In the CTM-SC tank (B1). So that the level
sensor works properly, it is necessary to set it up for the test liquid.
Check the settings at the level sensor, as described in the "Setting the level
sensor (B1) to the test liquid " chapter on page 41.
CTM-SC 3xxx series
en(us)
Page 27 / 56
BeWa CTM-SC 4165698b en-us 2017-05-10.docx
2017-05-10
Summary of Contents for CTM-SC 3 Series
Page 55: ......