Hyd-Mech S23P SERIES II, Manual

Page: 18 / 42

2.2
Manual Mode Machine Operation
Manual mode allows for a manual operation of the saw. In this mode all functions are activated be selection of the respec-
tive function button on the user interface.
To enter the manual mode after the main power has been turned off, press the Machine Start button. Follow the instruc-
tions on the display, and select the Manual Mode. A lit LED adjacent to the Manual Mode or Semi-Automatic Mode button
indicates machine mode.
Cut in Manual Mode
1 Open vise
2 Raise head
3 Position material
4 Close vise
5 Start blade
6 Press Cycle Start. To pause the head feed press Cycle Pause. To resume head feed press Cycle Start.
7 Machine will shut off blade when head reaches downward most position.
8 Raise head
9 Open vise
Semi-Automatic Mode Machine Operation
Upon initial power up, press MACHINE START. You will be prompted to press the reset button. Follow the onscreen in-
structions.
1 Set the HEAD UP and HEAD DOWN LIMITS. Refer to Setting Head Up and Head Down Limits.
2 Open vise by pressing the VISE OPEN button.
3 Position material.
4 Close the vise by pressing the VISE CLOSE button.
5 Start the blade by pressing the BLADE ON/OFF button.
6 Start the cycle by pressing the CYCLE START button.
HYDRAULIC FEED CONTROL (OPTIONAL)
The hydraulic feed controls are located on the left side of the control console and consist of the Feed Force Setting knob,
the Feed Rate knob and the Head Fast Approach lever. These controls allow the operator to control both the Feed Force
Limit and the Feed Rate. See Cutting Parameters Chart information
on the following pages.
Feed Force Control
Fast Approach
Feed Rate Control