HYCON HPP18V FLEX, Operating Manual

Page: 5 / 9

4
Starting Instructions
Please observe the starting instructions on the front of the powerpack.
Start:
 Check engine oil level
 Check hydraulic oil level at sight glass
 Connect hoses and tool
 Switch fuel tap to “ON”
 Activate choke
 Turn ignition key
 Activate electric start or pull recoil starter
 Set the flow – see below
Stop:
 Move all levers to “OFF“
 Turn off the ignition switch
 Turn the fuel tap to “OFF”
Setting of Flow
The powerpack has three connections, allowing for connection of two tools
simultaneously. The connections are marked A, B and C, respectively.
The oil flow can be adjusted by regulating the engine r.p.m. by means of the
throttle. Connection A can be set to 20-40 l.p.m. Connections B and C can be set to
10-20 l.p.m. Connection A cannot be used simultaneously with connections B and C.
Each connection is equipped with an ON-OFF lever. Connections not in use must be
set at OFF, and connections in use must be set at ON. Connections B and C can only
be used when connection A is OFF. Never turn the lever to ON if no tool is
connected.