56
TOOL LIST
APPENDIX 1
Hycomp compressor assemblies utilize “English Customary Measurements” for sizing tools and specifying torque
values, tolerances, and clearances.
Common tools and sizes suitable for Hycomp compressor service include:
o
Open end box wrench set 3/8” to 1-1/4”
o
12 point 1/2” drive socket set & ratchet 1/2” to 1-1/4”
o
6 point 1/4” drive socket set & ratchet 3/8” to 3/4”
o
1/4”, 3/8”, ½” socket drive extensions
o
1/2” drive torque wrench 20-150 ft-lb
o
3/8” drive torque wrench 5-80 ft-lb
o
6”, 8”, 12”, 14” adjustable end wrench
o
Flat head screwdriver assortment
o
Phillips head screwdriver assortment
o
Hex head wrench (Allen) assortment 5/32” to 3/8” (socket drive also suggested)
o
Internal snap ring pliers
o
Ball peen hammer
o
Soft head mallet
o
6” or 8” Precision caliper (.0001 accuracy)
o
Precision depth gauge dial indicator (.001 accuracy)
o ‘V’-belt
gauge
o
Gasket scraper tool
o 6”
Rule
o Flashlight
o Brass
drift
o Propane
torch
o
Multimeter (w/temperature probe desirable)
o Ammeter
o
Abrasive pad (ScotchBrite or similar)
o
Oil free silicone o-ring lubricant
o Te
fl
on pipe thread tape and Loctite 545 thread sealant
o
High temperature silicone gasket sealer
o
Thread locking compound (Loctite 242,246,and 266)
o
Pipe wrench and or monkey wrench
o
Pliers & diagonal cutter
o O-ring
pick
o
“Lock-Out / Tag-Out” set for secure power isolation
Special tools required for some service tasks include:
o
Hycomp Rod Clamp Tool P/N SA003 – Required for piston removal.
o
Hycomp Rod End Tool P/N SA004– Required for gas packing insertion.
o
“Short” 3/8” hex head (Allen) wrench – Required on some air cooled cylinders to remove base fasteners.
o
Hycomp Valve Clamp Tool P/N SA001– Required to remove/install threaded valve clamp.