4A
4. How To Set Up The Unit
4.1 Control Panel
Button:
1
MENU
To go forward select menu or go back to the last level menu
②
UP
To go forward select menu or increase parameters
③
DOWN
To go backward select menu or reduce parameters
④
ENTER
Enter submenu
⑤
Fuse
⑥
Mains input
：
Connect to supply mains power.
⑦
Mains output
：
Connect to supply mains power for the next unit.
⑧
DMX input: For DMX512 link, use 3-pin XLR plug cable to input DMX signal.
⑨
DMX output
：
For DMX512 link, use 3-pin XLR plug cable to link the next unit.
Note:
(1) In ten seconds, if no button was pressed, the LED display will turn off. Press any button
to turn on the LED display again.
(2) Whenever any button has been pressed, the program will save all parameter after 2
seconds
(3) No matter the program in which mode , once to detect the DMX or SLAVE signal,
the program will jump into DMX or SLAVE mode automatically. Then if DMX or SLAVE
