2
Setup
1.
Remove the battery cover from the back of the remote control.
2.
Insert 4 new AA batteries.
a.
Make sure the polarity of the batteries matches the diagram inside the battery
compartment (– matches with – and + matches with +).
3.
Push the battery cover back into place.
Programming
MODE (3 seconds) → digit → digit → digit
1.
Make sure you are in front of the device you want to program with the power
turned on.
2.
Using Device Codes (see pages 6-9), locate the brand name of your device.
NOTE: All codes are 3 digits and there may be more than 1 code listed for your device.
3.
On the remote control, press and hold the MODE button (TV, VCR, DVD or
CBL/SAT) until the indicator light in the upper left hand corner begins to blink
(this takes about 3 seconds).
4.
As soon as the indicator light begins to blink, release the MODE button.
5.
On the remote control, enter the 3 digit code for your device found in Device
Codes.
6.
Try different functions on the remote control to make sure the correct code was
entered.
a.
If only some or none of the functions work, repeat the steps above and try the
next code located in Device Codes. If there are no more codes listed, try Power
Scan.
Power Scan
MODE (3 seconds) → PWR → ▲ (PLAY) → ENTER (SELECT)
The Power Scan function checks every pre-programmed code in the remote control. Use
Power Scan if:
A.
Your device is not listed in Device Codes.
or
B.
You cannot program the remote control using codes located in Device Codes.
1.
Make sure you are in front of the device you want to program with the power
turned on.