3
1. Check the resonance of the antenna on the
40 Meter band. The SWR should be at a
minimum near 7 MHz or below.
2. To raise the operating frequency cut small
lengths such as
1
/4
inch lengths from each of
the four 40 Meter spokes. Check the
resonance point again.
Continue the previous steps until the desired
frequency is reached.
80 METERS
The 2:1 band-with on 80 meters is
approximately 40KHz. The top capacitance
spokes are adjusted to change the resonant
frequency on 80 meters. Cutting the four
upper capacitance spokes will raise the
resonant frequency. Follow the steps below
for proper tuning. Never cut the
capacitance spokes on the rounded ends.
1. Check the resonance of the antenna
on the 80 Meter band with the spokes
installed. The SWR should be at a
minimum near 3.5 MHz.
2. To raise the operating frequency cut
small lengths such as
'/4
inch lengths
from each of the four 80 Meter spokes.
Check the resonance point again.
Continue the previous steps until the desired
frequency is reached.
SERVICE INFORMATION
If you have a problem you are unable to
resolve or if you need to order replacement
parts, you should contact the Hy-Gain
Customer Service Department.
You should fully research your problem
by going through this manual before you
contact the Customer Service Department.
You should retain your sales receipt or
other proof of purchase for items that are
still under warranty.
All requests, inquires, warranty claims, or
for ordering replacement parts, you
should contact:
Hy-Gain
308 Industrial Park Road
Starkville, MS 39759 USA
Tel: 662-323-9538
Fax: 662-323-6551
NOTES:
