SECTION III
INSTALLATION
Disconnect the antenna from the CB transceiver
and unplug
the line cord from the wall outlet.
Connect the antenna to
the socket,
on the rear of the Receive Pre-Amp, marked
ANT.
Connect the short Iength of coax cabl e to the an-
tenna socket on the CB transceiver.
Connect the AC line cord from the CB transceiver
to the
AC outlet
on the Receive Pre-Amp marked XCVR.
The
other AC outlet
may be used for some other equipment
such as a lamp, extra receiver, etc.
Insert
the Receive Pre-Amp line cord into the AC wall
outlet.
DO NOT plug the CB transceiver into the wall outlet
It
must always be connected
to the XCVR outlet
on the
Receive Pre-Amp.
Connect the antenna to the socket marked ANT on the rear
panel of the Receive Pre-amp. Connect the short length of
coax cabl e to the antenn a socket on the CB transcei ver.
Connect the length of cable with the phono plug attached
to the socket marked
12v DC on the rear of the Recei ve
Pre-amp, strip the other end and splice
into the 12 volt
line that goes to the mobil'e CB transceiver.
The Receive Pre-amp MUST ALWAYS be switched on before
the mobile transceiver is switched on.
Failure to do so
could cause serious damage to the Receive Pre-amp.
To
help you remember this the Receive Pre-amp could be left
switched on all the time.
It has very little battery drain
(similar to an electric clocl .
