OPERATING PROCEDURES
MP35.940K
04SEP03
ROOM EXTEND PROCEDURE
CAUTION:
1. Unlock all room-locking devices.
room remove it before extending the room.
CAUTION:
extend the room.
4. To extend the room, press and hold the
ROOM CONTROL SWITCH in the "EXTEND" position
until the room is fully extended.
the operation of the room.
ROOM RETRACT PROCEDURE
3. To retract the room press and hold the
ROOM CONTROL SWITCH in the "RETRACT" position
until the room is fully retracted.
the operation of the room.
4. Engage all room-locking devices.
IMPORTANT: Room-locking devices should be
locked while traveling.
OPERATING THE ROOM WITH ANY
ROOM-LOCKING DEVICES LOCKED OR THE MANUAL-
RETRACT WINCH ATTACHED CAN CAUSE PERSONAL
INJURY AND VEHICLE DAMAGE. IT IS THE OPERATOR’S
RESPONSIBILITY TO ENSURE THAT ALL ROOM-LOCKING
DEVICES AND THE MANUAL RETRACT WINCH ARE
DISENGAGED BEFORE OPERATING THE ROOM.
KEEP PEOPLE AND OBSTRUCTIONS
CLEAR OF ROOM WHEN OPERATING.
3. The bay doors under the room extension must be closed.
CAUTION:
CLEAR OF ROOM WHEN OPERATING.
KEEP PEOPLE AND OBSTRUCTIONS
5. If the room will not retract see the MANUAL ROOM
RETRACT PROCEDURE.
NOTE:
NOTE:
NOTE:
NOTE:
If the MANUAL RETRACT WINCH is attached to the
Make sure there is adequate clearance to fully
Releasing the ROOM CONTROL SWITCH will halt
Releasing the ROOM CONTROL SWITCH will halt
IMPORTANT:
set, and the ignition is in the "ON" or "ACC" Position.
2. The bay doors under the room extension must be closed.
Do not operate the room extension unless the
vehicle is at the proper ride height and the leveling jacks are
retracted. If the vehicle is equipped with HWH air leveling,
the vehicle should be level before operating the room.
retracted. If the vehicle is equipped with HWH air leveling,
the vehicle should be level before operating the room.
vehicle is at the proper ride height and the leveling jacks are
Do not operate the room extension unless the
IMPORTANT:
2. Apply the parking brake, the ignition switch must be OFF.
after the room is fully extended or stops moving.
in the "EXTEND" position for more than ten seconds
of the room, do not reverse direction of the room until
after the room is fully extended. This assures proper
Hold the switch to "EXTEND" three or four seconds
pressurization of the cylinders.
Do not hold the ROOM CONTROL SWITCH
IMPORTANT:
NOTE:
During normal operation
the room is fully extended. If necessary, the direction
of the room may be reversed, but watch for binding of
the room. If the direction of the room has been
reversed, DO NOT re-extend the room until the room
has been fully retracted.
If either side of the room stops moving, release the
room control switch immediately. DO NOT force the
room. DO NOT reverse direction of the room, contact
HWH Customer Service for assistance 1-800-321-3494.
HWH Customer Service for assistance 1-800-321-3494.
room. DO NOT reverse direction of the room, contact
room control switch immediately. DO NOT force the
If either side of the room stops moving, release the
after the room is fully retracted or stops moving.
in the "RETRACT" position for more than ten seconds
Do not hold the ROOM CONTROL SWITCH
IMPORTANT:
NOTE: The room will not operate if the parking brake is not
1. Make sure the parking brake is applied.
The room will not operate if the parking brake is not
set, and the ignition is in the "ON" or "ACC" Position.
NOTE:
room may be reversed, but watch for binding of the room.
retract the room until the room has been fully extended.
If the direction of the room has been reversed, DO NOT
room is fully retracted. If necessary, the direction of the
the room, do not reverse direction of the room until the
Hold the switch to "RETRACT" three or four seconds
after the room is fully retracted. This assures proper
pressurization of the cylinders.
NOTE:
During normal operation of
The ignition switch must be OFF.
