OPERATING PROCEDURES
MP35.4724
28JUL98
GENERATOR SLIDE EXTEND PROCEDURE
CAUTION:
CLEAR OF SLIDE WHEN OPERATING.
NOTE:Make sure there is adequate clearance to fully extend
the slide.
3. To extend the slide, press and hold the GENERATOR SLIDE
CONTROL SWITCH in the "EXTEND" position. When the
slide is fully extended, release the GENERATOR SLIDE CON-
TROL SWITCH.
IMPORTANT: Do not hold the GENERATOR SLIDE CONTROL
SWITCH in the "EXTEND" position for more than ten seconds
after the slide is fully extended or stops moving.
NOTE: Releasing the GENERATOR SLIDE CONTROL SWITCH
will halt the operation of the slide.
GENERATOR SLIDE RETRACT PROCEDURE
3. To retract the slide, press and hold the GENERATOR SLIDE
CONTROL SWITCH in the "RETRACT" position. When the
slide is fully retracted, release the GENERATOR SLIDE CON-
TROL SWITCH.
after the slide is fully retracted or stops moving.
SWITCH in the "RETRACT" position for more than ten seconds
Do not hold the GENERATOR SLIDE CONTROL
IMPORTANT:
Releasing the GENERATOR SLIDE CONTROL SWITCH
will halt the operation of the slide.
NOTE:
KEEP PEOPLE AND OBSTRUCTIONS
2. THE PARK BRAKE MUST BE SET FOR THE SLIDE TO
OPERATE.
1. Turn the ignition key on.
IN THE EVENT OF FAILURE OF THE GENERATOR SLIDE
TO RETRACT, CONTACT HWH CORPORATION CUSTOM-
ER SERVICE AT 1-319-724-3396 OR 1-800-321-3494 FOR
ASSISTANCE.
2. THE PARK BRAKE MUST BE SET FOR THE SLIDE TO
OPERATE.
1. Turn the ignition key on.
