HWAM I 30/65, User Manual, Page: 15 / 20

Page 15 of 20 pages
c
leanIng
External cleaning
Cleaning of the insert should only be performed when it is not in use/cool. Daily maintenance is limited
to a minimum. It is easiest to vacuum the outside of the insert with a tiny nozzle with soft brushes.
Cleaning the glass (drawing G)
If it becomes necessary to clean the inside of the glass pane, lift the door halfway up and pull out the
two top guide latches
(1)
on each side of the door in order to loosen them from the screws
(2)
. The
glass scan then be tilted out and cleaned. Once the glass is clean, lift the door again halfway up, pull out
the top guide latches on the sides, ease the glass pane into place, and lead the guide latches back into
place over the screws.
The inside of the glass pane is best cleaned with damp paper towel dipped in ash. Afterwards, dry with a
clean paper towel. The outside of the glass can be cleaned with ordinary cleaning solvent used to polish
surfaces. We recommend wiping down the window pane when the insert is not in use/cool.
Ash
We recommend removing ash from the combustion chamber with an ash suction device. Make sure you
keep the air slot at the bottom of the rear plate free from ash.
Ash can be disposed of through daily refuse collection. Be aware that embers in the ash can
remain hot up to 24 hours after the fire in the insert has gone out!