HWAM 4510, User Manual

Page: 12 / 24

12
Distance to inflammable materials
Your HWAM stove must always be installed on a non-combustible foundation. If it is set up on a wooden
floor or another combustible material, the floor must always be covered with non-combustible material,
e.g. a floor plate. The width and depth (distance in front of the stove) of the non-combustible material are
determined according to relevant national and local building regulations. If there is risk of embers falling
under the stove, the non-combustible material must also cover the floor under the entire bottom plate
of the stove as well as the area next to the stove in accordance with national rules. The non-flammable
material must be of a size that is sufficient to prevent embers from falling out on the combustible floor.
Min. distances - uninsulated flue gas pipe:
(drawing A) With steel cladding With stone
cladding
HWAM 4510
HWAM 4530
HWAM 4550 HWAM 4520
HWAM 4540
HWAM 4560
HWAM 4540
HWAM 4560
1.
Recommended for brick wall, back, cm
10 10 10
2. Recommended for brick wall, side, cm
30 10 10
1. For inflammable wall, back, cm 10 10 10
2.
For inflammable wall, side, cm
59 35 40
1.
To inflammable wall, corner installation, cm
33 7 7
3. Distance to furnishings in front, cm
120 110 110
IMPORTANT FOR UK (for all other countries please see separate text below)
• In case of wall installation, HWAM 4510/4520 must be suspended at least 17.5 cm above
an inflammable floor (measured from the bottom plate of the stove). The above require-
ment applies even if the floor is fitted with a floor plate.
• The variant HWAM 4510/4520 without a plinth must be installed on a BS non combustible/
constructional hearth. The non combustible/constructional hearth must extend 425 mm
in front of the appliance. It is still considered a combustible floor even if an ember catch-
ing, non-combustible floor plate is placed on top of the combustible floor. Floor in front
exceed 100°C demand closer than 425 mm in front of the stove installed without a plinth.
• Floor directly beneath the stove installed without a plinth does exceed 100°C.
Take note of the applicable regulations for the distance between the wall and flue pipe.
The distance to a brick wall is set to faciliate the servicing of the HWAM Autopilot IHS
TM .
Please be aware that not all glass parts are heat-resistant. For this reason, a glass wall should sometimes
be treated as a flammable wall, in which case we ask you to contact your local chimney sweep or glass
producer to hear at what distance the stove should be kept from glass.
IMPORTANT FOR ALL COUNTRIES BUT UK (for UK please see separate text above)
• In case of wall installation, HWAM 4510/4520 must be suspended at least 28.5 cm above
an inflammable floor (measured from the bottom plate of the stove). The above require-
ment applies even if the floor is fitted with a floor plate.
• HWAM 4510/4520 without a plinth and HWAM 4510/4520 with a low plinth must not be
mounted on combustible floors. It is still considered a combustible floor even if an ember
catching, non-combustible floor plate is placed on top of the combustible floor.
• A non-combustible structure under HWAM 4510/4520 without a plinth and HWAM
4510/4520 with a low plinth must extend at least 480 mm in front of the stove.
Take note of the applicable regulations for the distance between the wall and flue pipe.
The distance to a brick wall is set to faciliate the servicing of the HWAM Autopilot IHS
TM
.