Poseidon 3262 – starting guide
HW group
Oficjalny dystrybutor:
www.atel.com.pl
45-231 Opole
tel. +48 (77) 455 60 76
ATEL ELECTRONICS
e-mail: [email protected]
ul. Oleska 121
fax. +48 (77) 455 80 56
Starting Guide – Poseidon 3262
First steps for remote monitoring with Poseidon & GSM
1) Connecting the Poseidon 3262
•
Green POWER LED on the RJ45 socket lights up – power supply is OK
•
Yellow LED on the RJ45 socket blinks – connection to 10 Mbit network is OK
Accessories
600 166
Poseidon 3262
Poseidon 3262 unit
600 257
Poseidon 3262 Tset
Quick start set – contains a temperature sensor, AC adapter, etc.
600 242
Temp-1Wire 1m
Temperature sensor, 1m cable
600 005
Temp-1Wire 3m
Temperature sensor, 3m cable
600 056
Temp-1Wire 10m
Temperature sensor, 10m cable
600 311
Temp-1Wire-Outdoor 3m
Stainless steel outdoor temp sensor (–30°C to 120°C ), 3m cable
600 279
Humid-1Wire 3m
Humidity sensor, 3m cable (1m= 600 278)
600 333
Humid-1Wire 10m
Humidity sensor, 10m cable
600 330
HTemp-Rack19
Temp + humidity sensor, fits into a 1U rack slot
600 040
Poseidon T-Box
Hub to connect 5 IT bus sensors to a Poseidon unit
600 280
Poseidon T-Box2
Hub to connect 2 IT bus sensors to a Poseidon unit
Poseidon 3262
1.4) Connect temperature or humidity sensor to the IT
bus (Temp-1Wire or Humid-1Wire – RJ12 jack). The
jack must click in.
1.3) Connect the power adapter to a mains outlet (230 /
110V) and to the Poseidon power connector. The jack
must be plugged all the way in. The green LED lights up.
1.1) Check the DIP switches. For installation, set them as shown
in the picture (DIP1=Off, DIP2=Off).
1.2) RS-232 serial port for connecting a GSM modem or for
configuring the device.
1.5) Connect Poseidon to the Ethernet (using a
patch cable to a switch, cross-over cable to a PC)
Temp-1Wire-Outdoor
3m
600 311
Poseidon T-Box
600 040
Poseidon T-Box2
600 280
Temp-1Wire 1m
600 242
HTemp-Rack19
600 330
