6
CHANGES AND T YPING ERRORS RESERVED
CHANGES AND T YPING ERRORS RESERVED
4.3 T
able
TilTing
Unlock the lever under the table and tilt the table to the desired position using
the graduated scale. Lock the handle again.
Figure 2
4.4 T
able
adjusTmenT
• Vertical: to adjust the table vertically you must first loosen
the clamp lever and then set the height using the
lever A, figure 3. Retighten the clamp lever.
• Turning the table: loosen the clamp lever, rotate the table to
the desired position and tighten the clamp lever.
Figure 3
4.5 s
eTTing
The
speed
Make sure the machine is turned off and disconnected from the power source.
Figure 4
• Open the v-belt cover and relax the v-belt using the tension lever.
• Based on the speed table on the right-hand side of the head select the desired speed and place the v-belt in the
appropriate grooves of the pulleys.
• Tighten the v-belt and close the cover.
4.6 v
belT
Tension
The belt tension is correct when it moves about 10 mm inwards when light pressure is exercised.
A
