Huvema HU 410 x 800 VAC TOPLINE, Instruction Manual

Page: 8 / 30

Operation Manual of Horizontal Lath
8
33. Ensure the spindle of the lathe should be at the stop position when measuring the
workpiece jigged on the chuck.
34. When the measuring meter is used on the lathe, ensure the motor is at the stop
status.
35. Wear protective gears met with safe standard before making operation on the
lathe;
It is not allowed if taking off protective gears in a short period of time before
making operation on the lathe;
Wear protective gears properly.
36. Take cars of cuttings flying out from the lathe.
37. Select suitable guard plate on the operation position.
38. Never leap over or go around the chuck or the workpiece to make adjustment
when they are in running status;
Never leap over or go around the chuck or the workpiece to take something;
Take care of the place the workpiece is put when making adjustment of the lathe
or the workpiece;
Never leap over or go around the chuck or the workpiece to move the tool/lathe
to other position;
Never leap over or go around the chuck or the workpiece to tighten parts on the
lathe;
Never leap over or go around the chuck or the workpiece to remove iron chips.
39. Master suitable method to load, and never apply force from unsuitable position.
40. Never mount the workpiece too large or heavy toward the lathe.
41. Never mount the workpiece too large or heavy toward the operator.
42. Use necessary tools to treat the workpiece.
43. Never apply excessive force on the attachment or the operation lever.
44. Take care to jig the workpiece firmly.
45. Tighten all claws, nuts, screws and fasteners.
46. Always take care to use correct equipment.
47. Never make cutting beyond the ability of the lathe.
48. Do not apply excessive force to polish or to deburr.
49. Always take care to adopt suitable tool to deburr. Do not deburr in a hurry and
take care of burrs on the chuck and the workpiece.
50. Switch off power supply to stop all movements of the lathe before replacing the
exchange gears.
51. Take care if the chuck/parts could drop down when the lathe is in operation.
52. Must predict the distance of the possible collision before apron longitudinal feed
and cross side cross feed approach limit position, Stop feeding in a timely, Prevent
from collision, Accidents.