Huvema HU 410 x 800 VAC TOPLINE, Instruction Manual

Page: 12 / 30

Operation Manual of Horizontal Lath
12
3. Handling and Installation
3-1 The Weight of the Lathe and Hoisting
The weight of the lathe is shown on the manual.
Ensure that the hoister has enough hoisting capacity before hoisting.
Preparations and safety examination:
1. Remove all unfixed devices;
2. Fix the tail on the tail end of the bed;
3. Fix the saddle on the bed and tighten the fixation press plate on the tail of the
saddle;
4. Ensure screw, pin and fixation bolts on the ring of the hoister are reliably
tightened;
5. Only correct hoister can be used;
6. Check ropes if they are robust and reliable in case they are used.
Do not wind the hoisting tool around the bed as it can cause curvature and damage
of the leading screw and the smooth bar.
3-2 Handling
When handling the packed lathe, tie ropes as per the hoisting mark and positions on
the packing case to hoist, unload and place the machine levelly and stably without
over tilting.
3-3 Unpacking
After unpacking, first of all check appearance of the lathe and check attachments,
tools and documents as per the packing list.
3-4 Hoisting
Put the wooden pad nearing the guide rail for the hoisting tool to avoid bumping the
guide rail.
Hoist the machine gently off the ground, and make further adjustment of position of
the saddle if necessary so as to make hoisting more balanced.