2 / 6
3
Install exterior assembly
A
IMPORTANT: Before installation, make sure the latch is fully retracted (in the unlocked position) .
Route the cable below the latch.
B
Send the cable through the bottom horizontal slot in the mounting plate.
C
Secure the mounting plate with the supplied screws.
D
E
J
Keep Parallel to door edge.
unlocked
unlocked
Insert the torque blade
through the slot in the latch.
4
Install interior assembly
Connect the cable and ensure tight cable connection.
A
Rotate the turnpiece in vertical position and make sure
the latch is still fully retracted (in the unlocked position).
Insert the torque blade through the center hole in the
mounting plate.
B
Test the turnpiece for smooth rotation.
If turnpiece doesn’t rotate, repeat step 4C,
making sure the turnpiece in vertical position.
C
Tourque Blade
Secure the interior assembly
with the supplied screws.
D
K
IMPORTANT: Do not load batteries until lock is completely installed.
Remove the battery cover.
Locate the slot at the bottom and use your fingernail or a
flat head screwdriver to pry the cover up and pull it off.
A
G
F
5
Detect left/ right hand door installation
While the door is OPEN and UNLOCK, load 3 AA batteries
into the interior assembly.
IMPORTANT: For best results, use new, non-rechargeable
Alkaline batteries only.
Reset the lock to teach the lock the orientation of the door.
A
Press and hold the Reset button on the interior assembly
using a pen or a paper clip.
B
Load the last battery and keep holding the reset button for
10 seconds, until you hear the sound of “beep”. The latch
bolt will extend to learn the orientation of the door.
C
IMPORTANT: This step is required and crucial for the lock to operate properly.
unlocked