REV J
3-4
604856
Driving the Mower
After starting the engine, engage the steering control
levers and steer as follows:
To go forward,
push the steering control levers forward an
equal distance. Figure 3-7
To go in reverse,
pull the steering control levers rearward
an equal distance. Figure 3-7
To turn left,
move the right steering control lever farther
forward from neutral than the left steering control lever.
To turn right,
move the left steering control lever farther
forward from neutral than the right steering control lever.
Figure 3-7
Zero radius turn,
move one steering control lever forward
and the other steering control lever back of neutral. This
allows the drive wheels to counter-rotate. Figure 3-7
To stop or decrease speed,
move steering control levers to
neutral. When going forward pull back gently on steering con-
trol levers. When going in reverse push forward gently on
steering control levers.
For emergency stops,
when traveling forward or rearward,
place the steering control levers in the park brake position
immediately.
To make a three point turn to the right:
1.
Move the left steering control lever farther forward
from neutral than the right steering control lever and
start the turn. Figure 3-8
2.
Next, pull back on the steering control levers until they
pass neutral and the machine starts to go rearward.
Figure 3-8
3.
Pull the right steering control lever farther rearward
from neutral than the left steering control lever until
the rear of the machine pivots around. Figure 3-8
4.
Then, push the steering control levers forward until
they both pass neutral and the machine starts to go
forward. Figure 3-8
5.
Push the left steering control lever farther forward
from neutral than the right steering control lever and
finish the turn. Figure 3-8
IMPORTANT:
Damage to the hydraulic system compo-
nents may occur with rapid movement of the steering con-
trols.
To increase speed,
increase the steering control lever’s dis-
tance from neutral. The farther forward the steering control
levers are from neutral, the faster the mower will travel for-
ward. The farther back the steering control levers are from
neutral, the faster the mower will go in reverse.
Bypass valve rod shown in operating position
A.
Bypass valve rod
B.
Slot
Figure 3-6
Never make sudden stops or reverse direction,
especially when maneuvering on a slope. The
steering is designed for sensitive response. Rapid
movement of the control levers in either direction
could result in a reaction of the mower that can
cause serious injury.
A
B
DA
NGER
When moving in the rearward direction push for-
ward gently on steering control levers and avoid
sudden movement. Any sudden movement could
cause the front of the mower to come off of the
ground resulting in possible loss of control, caus-
ing serious injury or death.
Always be aware of what is behind the machine
before backing up. Do not mow in reverse unless
absolutely necessary. Always look down and
behind before and while backing up.
DANGER
WARNING