Installation (Cont'd)
To adjust the front glass please follow these steps
Before you start any adjustments make sure the cases are
level, Front to Back and side to side
Step # 1
To level the cases remove the front and rear close-offs, You
can adjust the Height by turning the base leg adjusters
When you turn the leg adjuster clock-wise the case will
go up.
When you turn the leg adjuster counter clock-wise the
case will go down.
IMPORTANT: Attempting to compensate for poor
installation practices by manipulating the canopy
hardware will result in unsatisfactory workmanship
and possibly cause hardware failure and/or injury.
Step 2: Adjust Glass Height
Front to Back: Loosen to
move, must be tightened
when adjustments are
complete
Glass Height: When
turned clockwise the
front glass will go up.
When turned counter-
clockwise the front
glass will go down.
5
To properly adjust the height of the glass requires that both hinge arms of each section of glass be loosened before
attempting to change the glass position.
Summary of Contents for Q1-SSN
