P/N 0515388_L
1-3
Medium Temperature
Excel
with
EcoVision II Doors
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
–NOT PUSHED– to reposition. To remove the
rider, remove bolts attaching rider to each leg.
BRACKET REMOVAL FOR NARROW
DOOR CASES
Narrow door cases have brackets attached to
the rider that must be removed. The brackets
are there to help protect the case from dam-
age while in transit. Remove the screws from
each bracket. The splashguard brackets must
be installed at the locations where the brackets
were removed.
MERCHANDISER LEVELING
Merchandisers must be installed level to ensure
proper operation of the refrigeration system
and to ensure proper drainage of defrost water.
During all steps of setting, joining and leveling
merchandisers, close attention to position and
operation must be maintained.
NOTE:
B
egin
lineup
leveling
from
the
high
-
est
point
of
the
store
floor
.
Preparation
1. Using store blueprints, measure off and
mark on floor the exact dimensions/locations
of the merchandiser footprint.
A 3-inch space
is required behind each merchandiser to prevent
condensation.
2. Snap a chalk line for the front and rear
positions of the base legs.
3. Mark the location of each joint from front
to back lines.
4.
FLOORS ARE NOT LEVEL!!!
When
working with two or more merchandisers to
be joined, the whole lineup must be leveled
on the same plane, left to right and front to
back. This means that the entire lineup must
be brought up to the level of the highest case in
the lineup.
Along the lines previously marked, find the
highest point of the floor by:
• Walking the floor and noticing any dips
or mounds;
• Using a string level; and
• Using a transit.
Leveling
Position the first merchandiser at the highest
point on the floor. Work outward from that
point to create the merchandiser lineup. Use
a 48 inch (1220 mm) or longer level for end-
to-end leveling. The rear edge of the top foam
panel of the merchandiser is a good location
for the level at the rear of the case, and the top
rail is a good location for the level at the front
of the merchandiser. For leveling the merchan-
diser front-to-rear, a 24 inch (610 mm) level
should be placed on the lower flange of the
merchandiser end frame. If the merchandiser
has a factory installed end, the level should be
placed on the canopy support brackets on top
of the merchandiser. Suggested level locations
are shown in the following illustrations.
Remove Bolts from Front
Shipping Rider
Shipping Bracket
