Hussmann ESBD, Installation And Operation Manual

Page: 24 / 34

STEP 10 – Clean drip pan assembly (gravity
cases).
Work from the rear of the case. Doors may be
lifted out for easier access to the drip tray.
Follow directions on label above the doors as
shown at right.
Separate the drip tube from the lower end of the
connector as shown below.
The drip tray assembly consists of sections.
Plates connect the sections in 6-, 8-, and 12-ft
cases. For better control, begin at the outside
retainers and work toward the middle. Insert
fingers into the retainer and rotate to the side as
shown in detail photos.
Support the drip tray
when rotating the last retainer. Once the last
retainer is disengaged, the entire drip tray
assembly will rotate down and forward.
P/N 0453549 5-5
Elite Service Merchandisers HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Pivot
Screw
Drip Trough
Drip Tube Connector
Connector
Retainers
Retainer Detail
Drip Pan Assembly