Hussmann ASC-LG, Installation And Operation Manual

Page: 13 / 36

Rev. 0506
1
1. Allow cases to come to room temperature
2. Scrub thoroughly, cleaning all surfaces, with
soap and hot water.
3. Rinse with hot water, but do not flood.
4. Apply the sanitizing solution according to the
manufacturer’s directions.
5. Rinse thoroughly.
6. Dry completely before resuming operation
CLEANING
PRECAUTIONS
WHEN CLEANING:
Never Use a Cleaning or Sanitizing
Solution that has an OIL BASE
(these will dissolve the butyl
sealants) or AMMONIA BASE (this
will corrode the copper components
of the case)
TO PRESERVE THE ATTRACTIVE FINISH:
Do Use Water and a Mild Detergent for
the Exterior Only!
Do Not Use Abrasives or Steel Wool
Scouring Pads (these will mar the finish)
CLEANING GLASS & MIRRORS
Only use a soft cloth and mild glass clean-
er for cleaning any glass or mirrored compo-
nents. Be sure to rinse and/or dry completely.
never use hot water on cold glass surfaces! it
may shatter and cause serious injury! Allow glass
surfaces to warm first.
NON-GLARE GLASS CLEANING
The high optical clarity of this glass is possible due
to special coatings on the glass surface itself. To
preserve this coating and the optical clarity, keep the
glass clean.
Water is the only solution recommended to be used
to clean the non-glare glass. The damage to the glass
from improper, caustic solutions is irreparable.
In addition to cleaning the glass with the recommended
product, there are precautions that should be taken
when working and cleaning the inside of the case.
• When cleaning the inside of the cases, we
recommend that the glass be fully opened and
covered to prevent solutions from splashing
onto the glass and ruining the coating on the
inside.
PLEXIGLASS & ACRYLIC CARE
Improper cleaning not only accelerates the cleaning
cycle but also degrades the quality of this surface.
Normal daily buffing motions can generated static
cling attracting dust to the surface. Incorrect cleaning
agents or cleaning cloths can cause micro scratch-
ing of the surface, causing the plastic to haze over
time.
User Information, Cont’d
CLEANING
Hussmann recommends using a clean damp cham-
ois, or a paper towel marked as dust and abrasive
free with 210
®
plastic cleaner and polish available
by calling Sumner Labs at 1-800-542-8656 . Hard,
rough cloths or paper towels will scratch the acrylic
and should not be used.
ENCAPSULITE
SHATTERPROOF COATING - SA 10645
Complies with FDA USDA
& OSHA Regulations
for replacement call:
1-800-395-9229
Turn switch off then on after replacing bulb
nsF
U R
R
ANTISTATIC COATINGS
The 210 ® has proven to be very effective in not only
cleaning and polishing the Plexiglass surface, but
also providing antistatic and anti-fog capabilities. This
product also seals pores and provides a protective
coating.