1
B
2
3
2
1
MIN
SPECIFICATIONS - OPERATION - MAINTENANCE
EN - 31
EN
CHECK THE FRONT BRAKE FLUID LEVEL
The level of the fluid in the master cylinder reservoir
must never be below the minimum level visible through
the inspection sight glass (1) on the side of the master
cylinder (2) body.
A decrease of the fuel level will let air into the sustem, hence an
extension of the level stroke.
WARNING*:
If the brake lever feels mushy when
pulled, there may be air in the brake
lines or the brake may be defective.
Since it is dangerous to operate the mo
-
torcycle under such conditions, have the
brake system immediately checked by
the Husqvarna Dealer.
CAUTION*:
Do not spill brake fluid onto any paint
-
ed surface or lenses (for example lights
lenses).
CAUTION*:
Do not mix two brands of fluid. Com
-
pletely change the brake fluid in the
brake system if you wish to switch to
another fluid brand.
CAUTION*:
Brake fluid may cause irritation. Avoid
contact with skin or eyes. In case of con
-
tact, flush thoroughly with water and
call a doctor if your eyes were exposed.
REAR BRAKE PEDAL FREE PLAY ADJUSTMENT
Before starting braking action, the rear brake control
pedal (1) must have free play (B) of 5-10 mm (0.196
- 0.39 in).
Should this not happen, operate as follows:
- Loosen the nut (2);
- Operate the master cylinder linkage (3) to increase or
decrease free play;
- tighten nut (2) at the end of the operation.
WARNING*:
When the free play requirement is not
met, the brake pads will be subjected
to an early wear that may lead to TOTAL
BRAKE INEFFECTIVENESS.
