Husqvarna TC 50 2023, Owner'S Manual

Page: 67 / 196

SERVICE WORK ON THE CHASSIS 11
65
11.34 Installing the main silencer
K00673-11
Main work
–
Position main silencer.
–
Mount the main silencer with sleeve
1
.
–
Mount the silent block with screw
2
.
Guideline
Remaining screws,
chassis
M6 10 Nm (7.4 lbf ft)
–
Position the collar bushings.
–
Mount and tighten screw
3
.
Guideline
Remaining screws,
chassis
M6 10 Nm (7.4 lbf ft)
Finishing work
–
Install the right side cover. ( p. 57)
–
Mount the seat. ( p. 62)
11.35 Changing the glass fiber yarn filling of the main silencer
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
Info
Over time, the fibers of the insulating material vanish into the air, and the silencer "burns out".
Not only is the noise level higher, the performance characteristic changes.
Preparatory work
–
Remove the seat. ( p. 62)
–
Remove the right side cover. ( p. 56)
–
Remove the main silencer. ( p. 64)
700514-01
Main work
–
Remove screws with toothed washers
1
from the silencer
cap
2
.
–
Remove end cap and outer tube
3
.
–
Remove glass fiber yarn filling
4
from the inner tube.
–
Clean the parts that need to be reinstalled and check for
damage.
–
Mount the new glass fiber yarn filling on the inner tube.
–
Slide the outer tube over the glass fiber yarn filling.
–
Insert the end cap into the outer tube.
–
Mount and tighten the screws with the toothed washers.
Guideline
Remaining screws,
chassis
M6 10 Nm (7.4 lbf ft)