Husqvarna TC 50 2023, Owner'S Manual

Page: 116 / 196

16 SERVICE WORK ON THE ENGINE
114
K01173-11
(TC 50)
–
Remove screw
1
.
–
Check the gear oil level.
A small quantity of gear oil must run out of the drilled
hole.
» If no gear oil runs out:
–
Add the gear oil. ( p. 115)
–
Mount and tighten screw
1
.
Guideline
Screw, gear oil
level monitoring
M6 6 Nm (4.4 lbf ft)
16.4 Changing the gear oil
Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Drain gear oil with engine at operating temperature.
Preparatory work
–
Stand the motorcycle on the plug-in stand on a horizontal
surface.
K01172-10
Main work
(TC 50 MINI)
–
Position an appropriate container under the engine.
–
Remove oil drain plug
1
with the magnet.
–
Let the gear oil drain fully.
–
Thoroughly clean the oil drain plug with magnet.
–
Clean the sealing surface on the engine.
–
Mount and tighten the oil drain plug with the magnet and
new seal ring.
Guideline
Oil drain plug with
magnet
M12x1.5 20 Nm (14.8 lbf ft)