To replace the scraper bar
1. Put the scraper bar (A) in a reversed position
when it is worn to the edge of the housing.
A
2. Replace the scraper bar if it is worn on both
sides or if it is damaged.
Drive belts
WARNING:
The v-belts on your
product are of special construction and
should be replaced by original
equipment manufacturer (OEM) belts
available from your nearest service
center. Using other than OEM belts can
cause personal injury or damage to the
product.
WARNING:
The belt replacement
requires separation of the product. While
separating the auger housing from the
frame, it is important that an assistant
stands in the operating position and
holds the product handles. Serious
personal injury and/or damage to the
product could occur if the product falls
during the belt replacement process.
Note:
The auger and traction drive belts are not
adjustable. Replace the belts if they are damaged or
begin to slip from wear. It is recommended to have
the belts replaced by a qualified service center.
Note:
It is recommended to replace the drive belt
and auger belt at the same time.
To prepare for replacement of the belts
1. Remove the fuel from the fuel tank.
2. Loosen the lock nut (A) that secures the chute
rotator head (B) to the mounting bracket (C) to
remove the discharge chute.
B
A
C
3. Loosen the two screws (A) that secure the belt
cover (B) to the frame (C) and remove the belt
cover.
C
A
B
To remove the drive belt
auger belt on page 20
.
1674 - 004 - 18.05.2021
19
Summary of Contents for ST 324
Page 82: ...82 1674 004 18 05 2021 ...
Page 83: ...1674 004 18 05 2021 83 ...
