28 –
English
Maintenance
2
Replace the cutting height stay and the belt. Tension the
belt with the belt adjuster.
3
Fit the front cover.
4
Set the cutting height control to one of the positions 1-7
Checking the blades
To achieve the best mowing results it is important that the
blades are undamaged and well-sharpened.
Check that the blades’ attachment screws are tight.
Rider 11 C, 13 C, 16 C, 16 AWD
•
Put the unit in the service position, see Service position
for the cutting unit.
Rider 11 R
•
Lift up the cutting unit
•
Set the cutting height control in the highest position.
The blades should be balanced after sharpening.
Damaged blades should be replaced when hitting obstacles
that result in a breakdown. Let the servicing dealer judge
whether the blade can be repaired/ground or must be
discarded.
Removing the BioClip plug
To change a Combi unit from BioClip function to cutting unit
with rear ejection, remove the BioClip plug located under the
unit with three screws.
1
Put the unit in the service position, see Service position
for the cutting unit.
2
Loosen the knob holding the BioClip-plug and remove the
plug.
3
Replace the unit in normal position.
Fit the BioClip plug in the reverse order.
IMPORTANT INFORMATION
Replacing or sharpening the blades should be conducted
by an authorised service workshop.
!
WARNING! If the blades are cracked,
whether caused by poor repair or other
damage, they could break while being used.
The risk increases if the blades are poorly
balanced.
