Husqvarna RC 455, Operator'S Manual

Page: 17 / 100

English - 17
Menu functions Operator's Manual RC 455
Charge the battery
NOTE!
This chapter only concerns machines
equipped with a radio.
The remote control is equipped with a 7.2 volts battery.
The emergency stop on the remote control should always
be in the extended position when charging.
The battery can be charged as follows:
With the Canbus Cable (Part No. 531 11 50-12)
With the charging cable to the 12 volts outlet in the car
(Part No. 531 14 20-92)
With the charging cable to the battery charger (Part No.
531 11 72-54)
With the Canbus cable
Connect the Canbus cable between the remote control
and the unit. Make sure that none of the emergency stops
are pushed in and that the power unit is voltage fed.
Display “CHARGING THE BATTERY”.
The power unit can be used during charging.
Charging takes approximately 10 hours.
With the charging cable
Connect the charging cable between the remote control
and the 12 volt outlet in the car. Check that the emergency
stop on the remote control is not pushed in. The display
shows CHARGING THE BATTERY when charging is in
progress.
The charging time is approximately 6 hours.
NOTE! ONLY 12 V
To charge with the battery charger
Connect the charging cable between the remote control
and the battery charger. Now connect the battery charger
to a mains socket. Check that the emergency stop on the
remote control is not pushed in. The display shows
CHARGING THE BATTERY when charging is in progress.
The charging time is approximately 6 hours.
8. Radio channel
When the remote control is only used in battery mode,
a radio antenna must first be connected to the
smartbox:
Remove any cable connection.
Push in the antenna's connector in the socket on the
smartbox. Make sure that the slot in the antenna
connector aligns in the socket.
Screw on the connector's ring on the socket.
A radio channel must be selected when the antenna is
connected. Select:
0, 1 or 2
Confirm the selection by pressing OK and then arrow
down. The main information “Status” is then shown on
the display. Press arrow down again to continue in the
operations menu.