Husqvarna RA850, Operator'S Manual

Page: 7 / 36

servicing dealer, ask him for the address of
your nearest service agent.
To do a check of the cutting attachment and
the cutting attachment guard
WARNING: Do not use a cutting attachment
without an approved cutting attachment
guard. If an incorrect or defective cutting
attachment guard is installed, it can cause
injury.
1. Stop the engine and make sure that the cutting
attachment stops.
2. If you have a gasoline operated product, remove the
spark plug cap from the spark plug. If you have a
battery operated product, remove the battery from
the product.
3. Put on protective gloves.
4. Make sure that the blades are not damaged.
Replace the blades if they are damaged. Refer to
To
replace the blades on page 11 .
5. Examine the blades. Make sure that there is no
clearance between the blades. If there is a clearance
between the blades, the blades must be adjusted.
Refer to
To adjust the clearance between the blades
on page 11
.
6. Make sure that the support cup is not damaged.
Replace the support cup if it is damaged.
7. Make sure that the screws on the cutting attachment
are tightened.
8. Make sure that the blades and the cutting
attachment guard is not damaged. Replace
damaged parts.
Safety instructions for maintenance
WARNING: The cutting attachment can
continue to rotate after the throttle/power
trigger has been released. If you have a
gasoline operated product, remove the
spark plug cap from the spark plug. If you
have a battery operated product, remove the
battery from the product. Make sure that the
cutting attachment has stopped fully before
you do maintenance.
WARNING: The gear housing gets hot
during operation of the product. Hot surfaces
can burn you, do not touch the gear
housing.
• Always wear heavy-duty gloves when you repair the
cutting attachment. The cutting equipment is very
sharp and can easily cause cuts.
• Use only original spare parts for repairs.
1050 - 002 - 12.04.2019 7