Husqvarna R 418Ts, Operator'S Manual

Page: 27 / 48

English
– 27
Maintenance
Checking the tyre pressure
The tyre pressure should be 60 kPa (0.6 bar / 9 PSI) all round.
To improve driving the pressure on the rear tyres can be
reduced to 40 kPa (0.4 bar/5.6 PSI). The maximum tyre
pressure is 100 kPa (1,0 bar/14 PSI).
Checking the engine’s cooling air
intake
Clean the air intake grille in the engine cover behind the
driver’s seat.
Open the engine cover.
Check that the cooling intake is free from leaves, grass and
dirt.
A blocked cooling intake will interfere with the cooling of the
engine, which can damage the engine.
Replacing the rear drive belt R 418Ts
Removal
1 Lift up the cutting unit
2 Remove the transmission cover.
3 Unhook the spring (A) from the screw (B).
4 Remove the hose holder in the middle and the belt guide
for the centre belt.
5 Pull off the centre belt from the engine's pulley and pull out
the rear section.
6 Remove the cooling fan, it is held in place by a nut.
7 Remove the belt from the hydrostatic transmission pulley.
IMPORTANT INFORMATION
Different tyre pressures on the front tyres will result in the
blades cutting the grass at different heights.
!
WARNING! The cooling air intake rotates
when the engine is running. Mind your
fingers.
B
A