Husqvarna P 535HX, Operator'S Manual, Page: 27 / 304

• Make sure that all nuts and
bolts are tightened correctly
and that the equipment is in
good condition.
• Do not change the adjustment
of governors. If the engine
speed is too high, the product
components can become
damaged. Refer to
Technical
data on page 67
for highest
permitted engine speed.
• The product is approved only
with the equipment supplied
or recommended by the
manufacturer.
Transport safety
• Use an approved transport
vehicle for transportation of
the product.
• A markets national or local
regulations can set limit to the
transportation of the product.
• The operator of the transport
vehicle is responsible to
attach the product safely
during transport. Refer to
To
safely attach the product on a
trailer for transport on page
65
.
Note: To move the product with
the power off, the automatic
parking brake must be
disengaged. Refer to
To tow the
product on page 66
.
Assembly
To attach the cutting deck - Combi 155,
R180
Note:
Make sure that the cutting deck and the product
are on level ground before you attach the cutting deck.
1. Put the lever for the hydraulic lift arms to the position
(B) to lower the lift arms.
A
B
C
D
WARNING:
Do not put the lever for
the hydraulic lift arms to the float position
(A). The force from the lift spring can
cause injury.
2. Carefully move the product into position in front of
the cutting deck.
3. Put the lift arms into the joint of the cutting deck.
4. Apply the parking brake.
5. Turn the power key to the STOP position.
1591 - 005 - 20.05.2021 27