2. Set the throttle control in the stop position.
Maintenance
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = Refer to the engine manual for instructions.
General product maintenance
Before use,
each 10 h
After the
first 20 h
Weekly,
each 100 h
Yearly, each
500 h
Make sure that there are no fuel or oil leaks.
*
Clean the product.
X
Make sure that nuts and screws are tightened.
*
Examine the throttle control for damage.
*
Make sure that the throttle control can move smoothly.
*
Lubricate the throttle control and the engine throttle wire.
X
Do a check of the oil level in the rammer leg.
X
X
X
Replace the oil in the rammer leg.
X
X
Tighten the bolts on the rammer shoe.
X
Engine maintenance
Before use,
each 10 h
After the
first 20 h
Weekly,
each 100 h
Yearly, each
500 h
Do a check of the fuel level and the engine oil level.
X
Clean or replace the air filter.
X
Clean and examine the cooling fins of the engine.
O
O
Replace the engine oil.
X
X
Replace the air filter.
X
X
X
Adjust the engine valve clearance.
O
Adjust the valve head clearance for the air intake and the
exhaust valves.
O
1167 - 003 - 09.03.2020
9
