6.2.4 To examine the ignition spark
1. Ground the spark plug to the cylinder.
2. Move the stop switch to the operation position.
3. Pull the starter rope handle.
If there is no spark, the problem can be a defective
spark plug, defective ignition cable or a damaged short
circuit cable. Examine the spark plug.
6.2.5 To examine the spark plug
The electrode gap must be .02 in/0.5 mm.
The electrodes must be free of dirt and oil. Clean with a
wire brush.
Note: An electrode with soft edges and damaged
ceramic around it can cause pre-ignition. You must
replace a spark plug with soft edges.
.02 in.
0.5 mm
1. Replace the spark plug with the test spark plug.
Servicing tools overview on page 12.
2. Move the stop button to the run position.
3. Ground the test spark plug.
4. Pull the starter rope handle as if you start the
product.
If there is a spark, the spark plug is defective. Replace
the spark plug. If there is no spark, examine the ignition
cable and the short circuit cable.
1451 - 001 - 02.04.2020
Repair and servicing - 27