Husqvarna K 6500 II Ring, Operator'S Manual

Page: 15 / 124

OPERATING
English
–
15
different from those intended could result in a
hazardous situation.
• Make sure that no pipes or electrical cables are routed
in the working area or in the material to be cut.
• Always check and mark out where gas pipes are
routed. Cutting close to gas pipes always entails
danger. Make sure that sparks are not caused when
cutting in view of the risk of explosion. Remain
concentrated and focused on the task. Carelessness
can result in serious personal injury or death.
• The guard for the cutting equipment must always be
on when the machine is running.
Service
• Have your power tool serviced by a qualified
repair person using only identical replacement
parts.
This will ensure that the safety of the power tool
is maintained.
Always use common sense
It is not possible to cover every conceivable situation you
can face. Always exercise care and use your common
sense. If you get into a situation where you feel unsafe,
stop and seek expert advice. Contact your dealer, service
agent or an experienced user. Do not attempt any task
that you feel unsure of!
Basic working techniques
• The machine is designed and intended for cutting with
diamond blades intended for ring cutters. The
machine shall not be used with any other type of
blade, or for any other type of cutting.
• Check that the blade is fitted correctly and does not
show signs of damage. See the instructions in the
sections "Blades" and "Assembly and settings".
• Check that the correct blade is used for the application
in question. See instructions in the section "Blades”.
• Never cut asbestos materials!
• Hold the saw with both hands; keep a firm grip with
thumbs and fingers encircling the handles. The right
hand should be on the rear handle and the left hand
on the front handle. On the front handle, do not hold
outside the isolated gripping areas. All operators,
weather right or left handed shall use this grip. Never
operate a power cutter holding it with only one hand.
• Stand parallel to the blade. Avoid standing straight
behind. In the event of a kickback the saw will move in
the plane of the blade.
!
WARNING! Under no circumstances
should you modify the original design of
the machine without approval from the
manufacturer. Always use original spare
parts. Unauthorized modifications and/or
accessories may lead to serious injury or
death to the user or others.
!
WARNING! The machine can be a
dangerous tool if used incorrectly or
carelessly, which can cause serious or
fatal injury to the operator or others.
Never allow children or other persons
not trained in the use of the machine to
use or service it.
Never allow anyone else to use the
machine without first ensuring that they
have read and understood the contents
of the operator’s manual.
Never use a machine that is faulty. Carry
out the safety checks, maintenance and
service instructions described in this
manual. Some maintenance and service
measures must be carried out by trained
and qualified specialists. See
instructions under the Maintenance
heading.
!
WARNING! Do not pull the power cutter
to one side, this can cause the blade to
jam or break resulting in injury to people.
Under all circumstances avoid grinding
using the side of the blade; it will almost
certainly be damaged, break and can
cause immense damage. Only use the
cutting section.
Cutting plastics with a diamond blade
can cause kickback when the material
melts due to the heat produced when
cutting and sticks to the blade. Never cut
plastic materials with a diamond blade!
Cutting metal generates sparks that may
cause fire. Do not use the machine near
ignitable substances or gases.