English –
17
3
Loosen the screws and carefully remove the cover
over the brake spring.
(see fi gure 3)
WARNING!
Exercise care to ensure the spring
does not fl y out and cause perso-
nal injury. Wear protective glasses.
6.1 Dismantling the chain brake
2
Carefully tighten the clutch housing in a vice.
Release the brake by using the saw's front hand
guard (A) as a tool. Mesh with the brake and tigh-
ten anti-clockwise until the brake is activated.
(see
fi gure 2)
Cleaning and inspection
•
Carefully clean and check all parts. Parts must
be replaced if cracked or show signs of other
defects. Always use original spare parts.
•
Measure the thickness of the chain brake band.
It must not be less than 0.6 mm at any point.
(see fi gure 5)
•
Lubricate the knee joint with grease.
4
Hold one hand over the brake spring; press a nar-
row screwdriver in between the rear section of the
spring and the clutch cover. Carefully pry upward
until the spring releases and runs onto the screw-
driver shaft.
(see fi gure 4)
Safety equipment
6 Safety equipment
1
Release the brake by moving the front hand guard
backward.
Loosen the bar nuts and remove the clutch cover,
chain and bar.
(see fi gure 1)
min 0,6 mm
Fig 1
Fig 2
Fig 3
Fig 4
Fig 5
A
Summary of Contents for Jonsered CS 2245
Page 1: ...Workshop manual 510 09 69 26 ...
Page 2: ......
Page 12: ...12 English 4 Special tools Special tools 11 4 6 9 1 2 3 7 8 10 M5 M6 5 M5 ...
Page 56: ...510 09 69 26 2008W19 ...
