Husqvarna HUV4210-E, Owner'S Manual

Page: 19 / 60

Controls and Indicators
Gasoline Vehicles
After starting the engine with the key switch and placing the Forward/Reverse handle in the FORWARD position, the
vehicle should accelerate smoothly to full speed as the accelerator pedal is pressed. When the pedal is released it
should return to the original position and the engine should idle.
BRAKE PEDAL
The brake pedal is the large pedal on the left with the word STOP molded into it (Figure 10) . To slow or stop the
vehicle, press the brake pedal with your foot (Figure 11) .
78
Figure 11 Brake Pedal
79
Figure 12 Park Brake Pedal
PARK BRAKE PEDAL
The park brake pedal is the small raised portion in the upper left corner of the brake pedal. It has the word PARK
molded into it and the words PARK BRAKE marked on top of it
(Figure 11) . To set the park brake, press the brake
pedal firmly and tilt the park brake portion of the pedal forward with your foot (Figure 12) . See following WARNING.
WARNING
• The park brake will release automatically when either the accelerator or brake pedal is pressed. The
park brake has multiple locking positions and should be firmly pressed and locked to prevent the
vehicle from rolling.
BATTERY WARNING LIGHT
Electric Vehicles Only
Electric vehicles feature a dash-mounted warning light (to the right of the key switch) that, when the vehicle is in
operation, indicates low battery voltage or, when the vehicle is being charged, indicates a charging problem. The
warning light is controlled by the onboard computer.
When the vehicle is in operation, the warning light will illuminate and remain illuminate if:
• Batteries’ voltage drops below 48 volts when there is no load on the batteries (the vehicle is stopped and there
are no accessories on).
2009 HUV4210 Owner’s Manual Page 17