Husqvarna FS 600 E, Operator'S Manual

Page: 25 / 452

The product suddenly stops
• If the work load is too heavy for the product, the
motor protection engages and stops the motor. Refer
to
Error indicator on page 25
.
The product stops during startup
Correct voltage supply is necessary for a good motor
performance. Too long extension cords or too weak
extension cords decrease the power of the motor during
operation.
• If the work load is too heavy for the product, the
motor protection trips and stops the motor. Refer to
Error indicator on page 25 .
• Make sure that the extension cords are not too long
or too weak. Try to start the product again.
• Make sure that the cutting blade moves freely.
• If the product continues to stop during startup, speak
to an approved service workshop.
Error indicator
A
The error indicator (A) comes on in these situations:
• The motor has been overloaded. The motor stops.
• There is a phase error. It is necessary to adjust the
power plug.
Let the motor protection become cool and the error
indicator go off before you start the motor again. You
must wait for approximately 60 seconds.
The working light does not start
• Examine the fuse for the working light. If the fuse is
broken, replace the fuse with a correct fuse. Refer to
Technical data on page 26
.
Transportation, storage and disposal
Transportation
• Remove the cutting blade before the transportation.
• This product is heavy. Be careful when you lift the
product, risk of injuries. Refer to To lift the product
on page 26
.
1620 - 004 - 25